Home / Events / DIY Workshop on Sensors Applications using SeeedStudio’s Grove Open-source Kit & MYOSA

DIY Workshop on Sensors Applications using SeeedStudio’s Grove Open-source Kit & MYOSA

Date: 02-10-2020

Time: 5:30 to 7:00 PM

Presentation Title: DIY Workshop on Sensors Applications using SeeedStudio’s Grove Open-source Kit & MYOSA

Speaker of the Session: Mr. Abhishek Jani

Affiliation: Secretary-cum-Treasurer, IEEE Gujarat Section Sensors Council Chapter

Bio: Abhishek Jani is a Bachelor of Engineering (Electronics Engineering) from Marwadi University, Rajkot. Currently he is working as Research Engineer in DA-IICT, Gandhinagar, Gujarat. His interest areas are: Electronic system design, Analog Circuits, PCB design, Embedded C, Embedded Systems Design, 3D model design and Robotics. Abhishek has published papers in peer reviewed international conference in the area of assistive technologies. He is an IEEE member and currently he is Secretary cum Treasurer of IEEE Sensors Council Chapter of Gujarat Section.

Abstract: Seeedstudio’s Grove beginner kit and MYOSA kits are modular prototyping system consisting of Arduino derived Mother Board and various modules including Sensors, Actuators & Display with standardized connector. The standardized connectors allow users to assemble the units with building block approach, compared to the jumper wires or solder based system.

The ‘plug and chug’ feature provides the users with ready-to-apply connections and it is much easier to assemble or disassemble, which simplifies the learning system for experimenting, building and prototyping.

One doesn’t have to worry about tons of wires and can directly jump to developing creative applications!

Figure 7: Panelist with Mr. Abhishek Jani in Middle Right Window

Participants: 43

IEEE Member/Non-member: 17/26

Registration fee: free

Leave a Reply